Skip to main content
Article
A Study of Life Prediction Differences for a Nickel-Base Alloy 690 Using a Threshold and a Non-Threshold Model
Journal of Nuclear Materials
  • B. A. Young, University of Akron Main Campus
  • Xiaosheng Gao, University of Akron, main campus
  • Tirumalai S. Srivatsan, University of Akron, main campus
Document Type
Article
Publication Date
10-1-2009
Abstract
In this paper we compare and contrast the crack growth rate of a nickel-base superalloy (Alloy 690) in the Pressurized Water Reactor (PWR) environment. Over the last few years, a preponderance of test data has been gathered on both Alloy 690 thick plate and Alloy 690 tubing. The original model, essentially based on a small data set for thick plate, compensated for temperature, load ratio and stress-intensity range but did not compensate for the fatigue threshold of the material. As additional test data on both plate and tube product became available the model was gradually revised to account for threshold properties. Both the original and revised models generated acceptable results for data that were above 1 × 10−11 m/s. However, the test data at the lower growth rates were over-predicted by the non-threshold model. Since the original model did not take the fatigue threshold into account, this model predicted no operating stress below which the material would effectively undergo fatigue crack growth. Because of an over-prediction of the growth rate below 1 × 10−11 m/s, due to a combination of low stress, small crack size and long rise-time, the model in general leads to an under-prediction of the total available life of the components.
Citation Information
B. A. Young, Xiaosheng Gao and Tirumalai S. Srivatsan. "A Study of Life Prediction Differences for a Nickel-Base Alloy 690 Using a Threshold and a Non-Threshold Model" Journal of Nuclear Materials Vol. 394 Iss. 1 (2009) p. 63 - 66
Available at: http://works.bepress.com/tirumalai_srivatsan/65/