Skip to main content
Article
Direct Rolling of As-Cast Ti–6Al–4V Modified With Trace Additions of Boron
Materials Science and Engineering: A
  • Raghavan Srinivasan, Wright State University - Main Campus
  • Daniel B. Miracle
  • Seshacharyulu Tamirisakandala
Document Type
Book Chapter
Publication Date
7-25-2008
Abstract
Trace boron additions to titanium alloys produce an order of magnitude reduction in as-cast grain size, leading to the possibility of significant simplification of ingot breakdown and thermomechanical processing procedures. In this study, the boron modified titanium alloy Ti–6Al–4V + 0.1B (wt.%) was hot rolled from the cast + HIP condition to thickness reductions of 50% and 75% in multi-step rolling sequences. Baseline alloys (without boron) in the cast and wrought (mill product) states were also processed under identical conditions for comparison. After 50% reduction in thickness at 750–950 °C (1382–1742 °F), the deformation behavior of cast Ti–6Al–4V + 0.1B is not noticeably different from that of standard Ti–6Al–4V mill product, whereas cast Ti–6Al–4V without boron exhibited extensive cracking. The boron-containing alloy could be deformed further to 75% reduction in thickness at 950 °C (1742 °F) without producing any macroscopic defects. The alpha phase shows a tendency to globularize during heat treatment after a 50% reduction in thickness to produce an equiaxed microstructure. The potential, therefore, exists for the production of slab and sheet stock with an equiaxed microstructure by directly rolling the as-cast titanium alloys modified with trace boron additions.
DOI
10.1016/j.msea.2007.10.053
Citation Information
Raghavan Srinivasan, Daniel B. Miracle and Seshacharyulu Tamirisakandala. "Direct Rolling of As-Cast Ti–6Al–4V Modified With Trace Additions of Boron" Materials Science and Engineering: A Vol. 487 Iss. 1-2 (2008) p. 541 - 551 ISSN: 0921-5093
Available at: http://works.bepress.com/raghavan_srinivasan/16/