Frictional properties of gouge bounding the solid dacite plug that extruded at Mount St. Helens during 2004 and 2005 may have caused stick-slip upward motion of the plug and associated seismicity. Laboratory experiments were performed with a ring-shear device to test the dependence of the peak and steady-state frictional strength of the gouge on shearing rate and hold time. A remolded gouge specimen (~0.012 m3 ) was sheared under constant normal stresses ranging from 5 to 200 kPa and at rates ranging from 10-6 to 10-3 m/s. The gouge exhibited rate-weakening behavior at rates lower than 1×10-4 m/s and rate-strengthening at rates above 5×10-4 m/s. Peak strengths occurred during the onset of shearing, when displacements were generally less than 0.5 mm. In slide-holdslide tests, the peak strength of the gouge increased logarithmically as hold times increased from 3 s to almost 105 s. Rate-weakening friction is a requirement for stick-slip behavior that is satisfied by the Mount St. Helens gouge. Indeed, regular stick-slip oscillations were observed in two experiments performed at the highest normal stress and lowest rates of shear. The conditions under which this stick-slip motion occurred indicate that the gouge also satisfies a second criterion for stick-slip behavior of materials exhibiting rateand-state dependent friction—gouge stiffness exceeds that of the ascending magma that drives upward motion of the plug. The presence of highly compliant magma as a driving element may be crucial for generating stick-slip instabilities at the shallow earthquake focal depths observed during the eruption.
Available at: http://works.bepress.com/peter_moore/4/