Skip to main content
Article
Optimization of Annealing Cycles for Electric Output in Outdoor Conditions for Amorphous Silicon Photovoltaic - Thermal Systems
Department of Materials Science and Engineering Publications
  • Joseph Rozario, Michigan Technological University
  • Joshua M. Pearce, Michigan Technological University
Document Type
Article
Publication Date
3-28-2015
Abstract
Previous studies with fixed operating temperatures have shown that hydrogenated amorphous silicon (a-Si:H) was a promising absorber layer for solar photovoltaic–thermal (PVT) systems because of (a) a low temperature coefficient and (b) the opportunity to reverse light induced degradation with thermal annealing. This study further refined the simulation of the optimal dispatch strategy for a-Si:H based PVT by studying annealing cycles and analysis of the degradation at other operating temperatures controlled by the varying ambient temperatures. Four representative case studies were evaluated for the combinations of high and low solar flux and high and low average ambient temperature. Electrically-optimized dispatch strategies are found for a range of PVT thermal insulating effectivenesses. The results showed significantly more electricity generation in all the case study representative regions except for areas dominated by low temperatures and low solar fluxes. These results indicate that a-Si:H PV performance can be improved in most populated regions in the world by integrating it into a PVT device and using spike annealing to reverse light-induced degradation effects. The model presented in this paper uses publicly-available data to implement suitable dispatch strategies and execute virtual performance analysis of PVT for any geographic location in the world.
Publisher's Statement

© 2015 Elsevier Ltd. Deposited here in compliance with publisher policies. Publisher's version of record: 10.1016/j.apenergy.2015.03.073

Version
Preprint
Citation Information
Joseph Rozario and Joshua M. Pearce, Optimization of annealing cycles for electric output in outdoor conditions for amorphous silicon photovoltaic–thermal systems. Applied Energy, 148, pp. 134–141 (2015). http://digitalcommons.mtu.edu/materials_fp/45