Skip to main content
Article
A study of the compliance of alarm installations in Perth, Western Australia: Are security alarm systems being installed to Australian Standard AS2201.1 - 'systems installed in a client's premises'
ECU Publications Pre. 2011
  • Robert Mclaughlin, Edith Cowan University
  • David J Brooks, Edith Cowan University
Publication Date
1-1-2006
Document Type
Conference Proceeding
Publisher
School of Computer and Information Science, Edith Cowan University
Faculty
Computing, Health and Science
School
Computer and Information Science, Centre for Security Research
RAS ID
4538
Comments

This paper was originally published as: McLaughlin, R. E., & Brooks, D. J. (2006 December). A study of the compliance of alarm installations in Perth, Western Australia: Are security alarm systems being installed to Australian Standard AS2201. 1-" systems installed in a client's premises". In proceedings of 7th Australian Information Warfare and Security Conference, Edith Cowan University, Perth Western Australia. Original article available here

Geolocate This Image
(-31.9505269, 115.86045719999993)
Abstract

This study presented an overview of the training available to intruder alarm installers. A survey of domestic and commercial intruder alarm systems (n=20) were completed across Perth, Western Australia, metropolitan area. The gathered data were evaluated against Australian Standard AS2201.1 for intruder alarm systems, to determine whether alarm installations comply with two parts of the standard, being that of control panel location and zone supervision. AS2201.1 requires that intruder alarm control equipment shall be located within the alarmed area, located outside the entry/exit point and operate as dual endofline supervision. The study presents significant findings into the compliance of installed intruder alarm systems. A significant proportion of the intruder alarms measured did not comply with AS2201.1, with the panel located outside an alarmed area (30%), located in the entry/exit point (15%) and not capable of dual endofline supervision (30%). These items contravene Australian Standard AS2201.1. Assumptions suggest that noncompliance is due to a lack of industry focused vocational training, industry self regulation and supervision, licensing regime and legislation. No single aspect could be considered ineffective; rather it is argued that all of these areas need to be addressed.

Disciplines
DOI
10.4225/75/57a8123aaa0cd
Access Rights

free_to_read

Citation Information
Robert Mclaughlin and David J Brooks. "A study of the compliance of alarm installations in Perth, Western Australia: Are security alarm systems being installed to Australian Standard AS2201.1 - 'systems installed in a client's premises'" Perth, Western Australia(2006)
Available at: http://works.bepress.com/david_brooks/40/