Skip to main content
System-Level Modeling Methodology of ESD Cable Discharge to Ethernet Transceiver Through Magnetics
IEEE Transactions on Electromagnetic Compatibility
  • Yingjie Gan
  • Xiaoying Xu
  • Giorgi Maghlakelidze
  • Sen Yang
  • Wei Huang
  • Byongsu Seol
  • David Pommerenke, Missouri University of Science and Technology
When a charged cable is plugged into an Ethernet connector, a cable discharge event (CDE) will occur. Ethernet transceiver pins are often affected by CDE as they are usually unshielded. The discharge current couples via the transformer and common mode chokes to the physical layer-integrated circuit and may damage it. This paper describes a methodology for CDE system-level modeling in SPICE taking the cable geometry into account via full-wave modeling and cross-sectional analysis. A charged cable model, a nonlinear magnetics model, an Ethernet transceiver pin model, and the traces in the system are combined to create a complete model. An Ethernet system suffering cable discharge was selected to illustrate the methodology. The simulation is compared to measurements.
Electrical and Computer Engineering
Keywords and Phrases
  • Cables,
  • Ethernet,
  • Network layers,
  • Transceivers,
  • Cable discharge events,
  • Cross sectional analysis,
  • Discharge currents,
  • Ethernet transceivers,
  • Full wave modeling,
  • Nonlinear magnetics,
  • Physical layers,
  • System-level modeling,
  • SPICE,
  • electrostatic discharge,
  • Ethernet transmission line pulse (TLP),
  • system efficient ESD design (SEED)
Document Type
Article - Journal
Document Version
File Type
© 2016 Institute of Electrical and Electronics Engineers (IEEE), All rights reserved.
Publication Date
Citation Information
Yingjie Gan, Xiaoying Xu, Giorgi Maghlakelidze, Sen Yang, et al.. "System-Level Modeling Methodology of ESD Cable Discharge to Ethernet Transceiver Through Magnetics" IEEE Transactions on Electromagnetic Compatibility Vol. 58 Iss. 5 (2016) p. 1407 - 1416 ISSN: 0018-9375
Available at: