Skip to main content
Article
Model track studies on fouled ballast using ground penetration radar and multichannel analysis of surface wave
Faculty of Engineering - Papers (Archive)
  • P Anbazhagan
  • Li-jun Su
  • Buddhima Indraratna, University of Wollongong
  • Cholachat Rujikiatkamjorn, University of Wollongong
RIS ID
37520
Publication Date
1-1-2011
Publication Details

Anbazhagan, P, Su, L, Indraratna, B and Rujikiatkamjorn, C, Model track studies on fouled ballast using ground penetration radar and multichannel analysis of surface wave, Journal of Applied Geophysics, 74(1), 2011, p 175-184.

Abstract
Ballast fouling is created by the breakdown of aggregates or outside contamination by coal dust from coal trains, or from soil intrusion beneath rail track. Due to ballast fouling, the conditions of rail track can be deteriorated considerably depending on the type of fouling material and the degree of fouling. So far there is no comprehensive guideline available to identify the critical degree of fouling for different types of fouling materials. This paper presents the identification of degree of fouling and types of fouling using nondestructive testing, namely seismic surface-wave and ground penetrating radar (GPR) survey. To understand this, a model rail track with different degree of fouling has been constructed in Civil engineering laboratory, University of Wollongong, Australia. Shear wave velocity obtained from seismic survey has been employed to identify the degree of fouling and types of fouling material. It is found that shear wave velocity of fouled ballast increases initially, reaches optimum fouling point (OFP), and decreases when the fouling increases. The degree of fouling corresponding after which the shear wave velocity of fouled ballast will be smaller than that of clean ballast is called the critical fouling point (CFP). Ground penetrating radar with four different ground coupled antennas (500 MHz, 800 MHz, 1.6 GHz and 2.3 GHz) was also used to identify the ballast fouling condition. It is found that the 800 MHz ground coupled antenna gives a better signal in assessing the ballast fouling condition. Seismic survey is relatively slow when compared to GPR survey however it gives quantifiable results. In contrast, GPR survey is faster and better in estimating the depth of fouling.
Disciplines
Citation Information
P Anbazhagan, Li-jun Su, Buddhima Indraratna and Cholachat Rujikiatkamjorn. "Model track studies on fouled ballast using ground penetration radar and multichannel analysis of surface wave" (2011) p. 175 - 184
Available at: http://works.bepress.com/crujikiatkamjorn/77/