Skip to main content
Event-Based Data Collection for Generating Actuated Controller Performance Measures
Civil Engineering Faculty Publications
  • Edward J. Smaglik, Purdue University
  • Anuj Sharma, University of Nebraska - Lincoln
  • Darcy M. Bullock, Indiana University - Purdue University - Fort Wayne
  • James R. Sturdevant, Indiana Depatment of Transportation
  • Gary Duncan, Econolite Control Products
Date of this Version

Transportation Research Record: Journal of the Transportation Research Board, No. 2035 (2007): 97-106. DOI: 10.3141/2035-11.


Copyright 2007, Transportation Research Board of the National Academies. Used by permission.

Cycle-by-cycle data have been shown to be effective in the analysis of a signalized intersection with measures of effectiveness such as volume-to-capacity ratios, arrival type, and average vehicular delay. Currently, actuated traffic controllers are unable to store vehicle counts and vehicle occupancy in cycle-by-cycle bins, requiring extra equipment and personnel to collect data in these bins. The objective of this research was to develop an integrated general purpose data collection module that time stamps detector and phase state changes within a National Electrical Manufacturers Association actuated traffic signal controller and uses those data to provide quantitative graphs to assess arterial progression, phase capacity utilization, movement delay, and served volumes on a cycle-by-cycle basis. Given that the United States recently received a grade of 61 of 100 on the National Traffic Signal Report Card, it is particularly important that procedures such as these be used to provide performance measures over extended periods so agencies have cost-effective mechanisms for assessing and priority-ranking signal timing efforts.
Citation Information
Edward J. Smaglik, Anuj Sharma, Darcy M. Bullock, James R. Sturdevant, et al.. "Event-Based Data Collection for Generating Actuated Controller Performance Measures" (2007)
Available at: