Microwave Signal Generation Using Self-Heterodyning of a Fast Wavelength Switching SG-DBR Laser

Michael A. Bernacil, California Polytechnic State University - San Luis Obispo
Shame O' Connor, California Polytechnic State University - San Luis Obispo
Ben Maher, California Polytechnic State University - San Luis Obispo
Andew Dekelaita, California Polytechnic State University - San Luis Obispo
Dennis J. Derickson, California Polytechnic State University - San Luis Obispo

Article comments

4 pages.

Copyright © 2008 IEEE. Personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution to servers or lists, or to reuse any copyrighted component of this work in other works must be obtained from the IEEE. The definitive version is available online at: http://dx.doi.org/10.1109/MWSYM.2008.4633238

Abstract

Microwave signal generation using self-heterodyning of a single wavelength tunable SG-DBR laser is demonstrated. Microwave signals are established by quickly hopping back and forth between two optical wavelengths. These wavelengths are made time coincident through a delay line interferometer. The output of the interferometer is photodetected resulting in a CW microwave signal. This method does not require conventional master-slave laser configurations, external microwave drive sources, or a mode locked laser used to beat dual longitudinal modes. Microwave signals up to 12 GHz have been measured by frequency modulating the phase section of the SG-DBR laser with low frequency RF square wave input currents. Millimeter wave difference frequencies are easily available from the SG-DBR. Temperature robustness of SG-DBR self-heterodyne signals was also investigated. While each laser wavelength by itself changes by 0.12 nm/C (21 GHz/C), the difference frequency temperature coefficient is well less than 30 MHz/C typically.