Polymer Thickness Effects on Bosch Etch Profiles
Time-multiplexed etching, the Bosch process, is a technique consisting of alternating etch and deposition cycles to produce high aspect-ratio etched features. The Bosch process uses SF6 and C4F8 as etch and polymer deposition gases, respectively. In these experiments, polymer thickness is controlled by both C4F8 gas flow rates and by deposition cycle time. The authors show that polymer thickness can be used to control wall angle and curvature at the base of feature walls. Wall angle is found to be independent of trench width under thin-polymer deposition conditions. Experimental results are compared to results obtained by other researchers using the more conventional simultaneous etch/deposition technique.
C. J.D. Craigie, T. Sheehan, V. N. Johnson, S. L. Burkett, Amy J. Moll, and W. B. Knowlton. "Polymer Thickness Effects on Bosch Etch Profiles" Journal of Vacuum Science and Technology B 20.6 (2002): 2229-2232.
Available at: http://works.bepress.com/amy_moll/22